Installation
This page walks you through the job, from what to buy to the first row of pieces and the final coat of paint.
- Is your wall ready?
- Run a level over the wall in a few places. Any bump or dip it shows has to be dealt with before the first piece goes up, so fill the holes and sand down the high spots. It also needs to be dry and clean, meaning no dust or grease, and solid. Loose paint or crumbling plaster has to be fixed first.
- Which walls work
- As long as it passes, drywall, plaster or a painted wall will take the pieces. There’s no need to tear out old tile that’s firmly attached and clean. Just scuff or prime it first. The pieces are made for indoor walls only, and in a bathroom they have to stay out of the way of direct water.
- Tools
- Get out a level, a tape measure and a pencil. You’ll also want a notched trowel, a fine-tooth hand saw, a small putty knife, a sanding sponge, and a roller and brush for the paint.
- Materials
- For the materials list, start with gypsum panel adhesive. A construction adhesive works too if its label says it’s for gypsum. You’ll also pick up joint compound, primer and interior latex paint, and if this is a bathroom, the primer and paint should be the moisture-resistant kind.
- The pieces
- Open all of the boxes before you start and lay the pieces out on the floor, so it’s easier to mix them as you go.
- Time and help
- Allow more than one day for the project, since the adhesive, joint compound and paint each need time to dry. One person can do it alone, though two people will get it done faster.
- 1. Level line
- Begin with a level line drawn where the bottom row will sit, or use the floor as your starting point if it’s straight and level.
- 2. Bottom row
- Along that line go the half pieces that come in the bottom-row box.
- 3. Rows above
- Spread adhesive on the back of a piece and press it onto the wall. Finish each row before starting the one above it, and check your work with the level every few rows.
- 4. Joints
- Each piece gets pushed up snug against its neighbors. The thin seam where two meet is filled later on, and once the wall is painted you won’t see it. Squeeze-out is easy to wipe off as long as the adhesive is still wet.
- 5. Cuts
- Pieces at the row ends and around outlets have to be trimmed to fit with the hand saw.
- 6. Drying
- Give the adhesive the full drying time printed on its label before you go on, since drying times vary by adhesive.
- Joints
- With a small putty knife, work joint compound into each joint and follow the shape of the relief as you go.
- Sanding
- Once it has dried you sand the joints smooth.
- Primer
- Prime the whole wall and not just the joints.
- Paint
- Finish with any interior latex paint in any color. Keep in mind that flat paint is harder to wipe clean than eggshell or satin.
- Cleaning
- Dust comes off with a soft brush or a dry microfiber cloth, and for marks a damp cloth with a little mild soap is enough if you go gently. Harsh cleaners and scrub pads shouldn’t be used on it.
- Small chips
- Joint compound takes care of them. Once it’s dry, sand the patch smooth and touch it up with the paint you used on the wall.
- Replacing a piece
- First cut along the joints around the piece. Pry it off and scrape the old adhesive from the wall. A new piece of the same pattern goes in, then you fill the joints, prime and paint.
- Spare pieces
- Repairs later on are quick if you keep one or two leftover pieces on the shelf.
- Installation video
- —
- Installation guide (PDF)
- —
Have a question?
Text us a photo of the wall and we’ll let you know. Chat on WhatsApp
How many boxes?
Put your wall’s width and height into the wall planner and it shows the boxes needed for every product.